Home > Gaming > Graphics Cards > X1900GT Rev 2 Voltage Mods
Graphics Cards

X1900GT Rev 2 Voltage Mods

Alright so you want to voltage modify your X1900GT Rev2, with that new cooler, changed PCB? No software voltage adjustments? No worries, here’s some simple mods for you, all the way up to 1.85v!

Alright so you want to voltage modify your X1900GT Rev2, with that new cooler,
changed PCB? No software voltage adjustments?

Sure, measure VGPU at any of the sides of capacitors marked on the back of
your card:

So yes vgpu default at 1.13v.

 

Now locate the Volterra VT1165 chip behind the card.

Locate the resistor marked above. It should read about 10.9K ohms. Now pencil
this resistor, such that it reads 5.9k ohms to 6kohms: Must be as close as possible!
Or solder a 100K ohms Variable Resistor across the resistor and adjust resistance
until the resistor reads 5.9k ohms to 6kohms: Must be as close as possible! This must be done before any voltage adjustments below!!

Now next step you gotta decide what voltage you want to run. Look below for
1.35v.

1.35v

Ok, use conductive ink, connect the side of resistor and the solder pad right
beside as you can see above marked in green. It will give you 1.35v

For the following voltages, do similarly, the green line represents your conductive
ink! For above 1.35v you better have some good cooling!!

1.45v

 

1.55v

 

TeamVR
http://vrzone.com
VR-Zone is a leading online technology news publication reporting on bleeding edge trends in PC and mobile gadgets, with in-depth reviews and commentaries.

Leave a Reply

Your email address will not be published.

Read previous post:
Sapphire Water-Cooled TOXIC X1950XTX

Adding silent cooling to the highest level of graphics performance, Sapphire Technology has just introduced a new TOXIC water cooled...

Close